Tone Deft wrote:I assume you mean zero crossings at the beginning and end of loops. you don't need to find zero crossings, Live fades clips' start and end points. get sloppy with it and see if you've been too picky with it. I warp to what swing sounds good, not for zero crossings.
if you can make a loop that clicks because you didn't find the zero crossings, please post a .als.
No, I didn't mean that. I always set the markers to the last zero crossing before the transient... not because of clicks, but because this is the correct starting point for a single warp marker.
However I have to admit that after I found out about the shift key, fine adjustment is possible again and therefore everything's fine