Ableton Forum

MANY thanks!!!!!

Gabster

Hi Gang! Two quick routing questions while recording on a audio track: 1. If I have certain effects on the audio track - will the final audio recording be altered by them? 2. Does the track volume have to be set at 0 db while recording? In other words, will the track Volume affect the final recordin...

Thanks a TON!!

I found what I needed there -

cheers!
Gabster

Sorry...

What I would like to do is heighten pitch (make the speaker's voice squeakier) preserving the same time - unlike spinning a record where pitch AND time is affected... I tried with "transpose", but the result is not smooth. I have warp turned off.

thanks!!
g

hi knowledgeable folks...

what's a common method to stretch pitch but keep the same time on an audio clip. Bpm is irrelevant because the recording is a speech...

thanks!!
gabstero

ark wrote:

gabster wrote:WHat would be a decent note range to work with for a bass line? C0 C1 C2? I am shooting for a fat bass audible in a decent club PA system - considering they have subwoofers that go down to 40 Hz or so.

The low E of a bass guitar is 41 Hz.

So that would be E1, right?

thanks.

Hi Gang!

WHat would be a decent note range to work with for a bass line? C0 C1 C2? I am shooting for a fat bass audible in a decent club PA system - considering they have subwoofers that go down to 40 Hz or so.

cheers!
Gabster

Keith - got it!! Thanks a ton!

Gabster

Thanks a ton for the reply!! I saw the automation button (the + sign) that shows you the automation lane - but there I wasn't able to select anything unfortunately - Am I looking in the right place? I have an audio track -

thanks!
Gabster.

Hi knowledgable folks!

This might be very obvious but... How does one automate an effect to turn on or off on a track in Arrangement view?

Thanks,
Gabster

Angstrom - thanks

it makes sense. Gosh - one would expect to have the same markings in there as well - such a feeble thing. Maybe in the next version...

thanks!
Gabster

Thanks, Angstrom -

But is this valid for the arrangement view? I wasn't able to get the db markings...

thanks!
Gabster

Hi Gang!

Simple question - how do I turn on the db marking next to the input VU-meter on a channel in arrangement view?

I am so used to see the numbers where a signal should peak.

thanks!
gabster

Slightlydelic wrote:you might get an aproxomation of a tape stop from beat repeat using pitch decay

Can you please tell us how you automate the pitch decay - thanks,
gabstero

ionic wrote:set warp to repitch, then automate the tempo slowing down.

Do you mind elaborating on warp to repitch a little please?

Thanks!
Gabstero