Page 1 of 1
Snapping Automation Breakout Points To Grid
Posted: Tue Feb 09, 2010 1:48 pm
Is there a way to snap the breakout points of automation envelopes onto the grid without having to zoom in all the way?
Re: Snapping Automation Breakout Points To Grid
Posted: Tue Feb 09, 2010 6:05 pm
Till now I didn't figure out how to do this. I think it's impossible in current version of Live, which, if true, is lame.
Workaround which I use to snap ideally is to switch to Pencil Tool and draw a horizontal line between two grid lines (one of these lines is the one you want to put point on) then switch back to previous mode and you have points on both lines ideally snapped, then you just erase those which you don't need by double-clicking on them.