Hello,
I was wondering if I could change how I have to move faders and knobs a pre-determined amount before they become active in controlling ableton. This is especially the case when I MIDI remap the sends to effects. When I change the send bank on the APC when performing, I have to turn all those knobs to even use the effect.
Thanks,
Dustin
APC40 MIDI Activation Question
-
- Posts: 1104
- Joined: Fri Jan 12, 2007 11:48 am
Re: APC40 MIDI Activation Question
Not sure, if I understand you correct, but you can alter min/max values in the left side browser while Live's in midi mapping mode. Check that out, in case you haven't done so yet.
MBP OSX 10.6.8, Live 8.4, MFII, Evolver, Monomachine, Octatrack, APC40, Launchpad
Re: APC40 MIDI Activation Question
Also change your takeover mode to value scaling...
Cheers
D
Cheers
D