Ableton Forum

Ok heres what im doing:

# Ive bounced out stems from logic 9 and im bringing them into live. (holding tab on all of them so that they run vertically down arrange view)
# Ive made sure that Autowarp long samples is off.
# Ive made sure that loop/warp short samples is set to unwarped one shot
# The project tempo in Ableton is the same as in Logic.

There is a quicktime MOV that I have exported from Final Cut Pro that contains a bounce of the logic session intime to the video.

The problem is is that the logic stems that I have imported match with themselves but not with the audio in the quicktime MOV

Can anyone help me out here?

Cheers

Slide the audio from the movie until it lines up?

Thats the problem, I cant do that because it looks like the audio from the video is a different speed to the audio from logic. The first hit will be in time but then it gets progressively more and more out of time. I can't warp the video because they obviously shot it they way they did and i cant change that. I also cant warp the tracks because there are about 60 of them and i would have to go through every piece of audio in each track and move it..

could be a video frame rate issue? years back i was having a similar issue and i seem to remember it was all down to a mov frame rate difference. it was made at 29.97 but was playing at 30 fps (or something like that), so that was the cause of the drift.