Sampler 1 voice mode clicks at the start of each note

[UCAudio]

Is there a way to make Sampler not have a clicking sound at the start of each note when you've enabled only one voice? I have a bass synth sample set and want to play it monophonic only allowing 1 voice, but sampler adds a noticeable clicking sound at the start of each note. It's really noticeable when you're low pass filtering stuff. It sounds pretty bad. Any workarounds for this?

[outsidesys]

Try moving the sample start to a zero crossing, or increase the Attack phase of the Amp Envelope.

[chrk]

Try moving the sample start to a zero crossing, ...

and/or engage the Snap button, so Sampler detects zero crossings automatically.

Also you may have a look at your samples in an audio editor to see if they are cut at zero crossings.

I've seen samples from a 'commercial sample pack' just recently, that had been cut half way through a cycle just befor the transient of a kick drum. That sounded nasty.