Page 1 of 1
How to make glide transitions with operator?
Posted: Tue Apr 28, 2015 2:49 pm
by Underground Surface
Is there any way to make the transitions between notes? Glide doesn't work properly in my case. Operator sub bass is clicking when each note begins. By using the retrigger, and without using it, sub bass still clicking at the beginning of the each note.
Re: How to make glide transitions with operator?
Posted: Tue Apr 28, 2015 3:00 pm
by empathy1
adjust your attack/release on your primary oscillator if using FM; all if using additive. glide cannot compensate for clicks; those result from envelope afaik
Re: How to make glide transitions with operator?
Posted: Tue Apr 28, 2015 10:06 pm
by paulmaddox
Maybe need to turn retrigger off on some/all oscillators too
Re: How to make glide transitions with operator?
Posted: Thu Apr 30, 2015 12:46 pm
by coulis
Are voices set to 'mono'?
Re: How to make glide transitions with operator?
Posted: Mon May 04, 2015 4:22 pm
by Underground Surface
coulis wrote:Are voices set to 'mono'?
Thanks, I already have solved this problem. I just did the notes shorter, I changed the attack, release, and I've made the transitions between notes.
Re: How to make glide transitions with operator?
Posted: Wed Jun 28, 2017 5:38 pm
by marra
Anybody got an adg they could share? I've been struggling to make a bass like this
https://www.youtube.com/watch?v=cFAMlBBJzCg using Ableton Operator and no samples. So far all I've done is set wave to sine 8 and voice to 1.
Re: How to make glide transitions with operator?
Posted: Fri Jun 26, 2020 9:41 pm
by aaallleeexxx
"Operator includes a polyphonic glide function. When this function is activated, new notes will
start with the pitch of the last note played and then slide gradually to their own played pitch.
Glide can be turned on or off and adjusted with the Glide Time control in the pitch display."