ableton stemming issue

Discuss music production with Ableton Live.
Post Reply
Mikhailmusic
Posts: 25
Joined: Sat Aug 23, 2014 8:32 am

ableton stemming issue

Post by Mikhailmusic » Sat Aug 13, 2016 11:08 pm

I'm not sure if this is an obvious fix because I'm still new to Ableton. I'm using 9.7b3. Everytime I want to stem out my arrangement, the bounced stems are only 4 bars when I know the arrangement is much more. I make sure the loop box is the length of the arrangement I want. I select all the clips in the arrangement. I use push 2 but clip mode is off (No Red Box). I choose All Tracks when exporting, yet my results have only been the stems bouncing to 4 bars.

Weird thing is when I bounce the Master the same exact way, I get my full arrangement in the bounce...just not using all tracks.

Suggestions?

Tarekith
Posts: 19072
Joined: Fri Jan 07, 2005 11:46 pm
Location: Ableton Forum Administrator
Contact:

Re: ableton stemming issue

Post by Tarekith » Sun Aug 14, 2016 11:10 am

Click on the back to arrangement button in Live before you render, and double check the full arrangement length is set in the render dialogue too.
Tarekith
Ableton Forum Administrator
https://tarekith.com

Post Reply