I have a rather bizarre problem since I updated my OS, the
Live set I was working on doesn't seem to load the sounds properly of U-he synths + the wrong parameters are automated.
macOS Yosemite
Ableton 9.7.7
Ace 1.1 or 1.4
The sound is correct, the parameter names which are automated are:
"Cuttoff"
"Release"
macOS Sierra 10.12.6
Ableton 9.7.7
Ace 1.1 or 1.4
The sound is similar to the original but clearly different, the parameter names which are automated are:
"VCF1:Res"
"ENV1:LMod"
As you can see, the automated parameter names are wrong. When I correct the automation by hand, I can get the original sound back,
except I get glitches on fast arpeggios while on the original on Yosemite not. (same audio buffer and other plugins work fine).
I tested both ace 1.1 and the latest 1.4, but it's all the same.
I did deep installed/reinstalled both Ableton and Ace with no luck.
This problem is close to other problems with U-he/massive/audio units and Ableton 10.0.2, but since this is Ableton 9, this is not it.
viewtopic.php?f=1&t=230680
(I was dealing with these problems as well, so it's quite complicated :S)
EDIT: new problem: after reopening the set, the hand-corrected Ace sounds wrong, not just the automation, the whole sound is off compared to the original.
I can double check this wasn't before, because I made an audio recording of it before I saved the set. I was so sure this was a Live 10.0.2/audio units problem,
but I'm in Live 9 now :S.
EDIT2: I have the same problems with vst and au.