I regularly use multi-output audio interfaces. While programming I use a iConnectAudio4+, and on stage I use a X-Air 18.
When I pull up my Ableton live sets, they work when developing and when performing due to alike number of outputs.
Desire:
If I work offline (just the Mac), it uses the "Built-In Output" of the Mac. This is only 2 channels. Left & Right.
I lose the channels set to 3 & 4 (stereo), 5 (mono), 6 (mono), 7 & 8 (stereo), etc...
I know I can reroute these, but then when I perform live, I have to reroute them all again.
Question:
Is there a way, on a Mac, to have multiple virtual outs that mix to L & R of the "Built-In Output" where I don't need to disturb my Ableton output assignments?
[MacOS] Virtual Outputs?
[MacOS] Virtual Outputs?
MacBook Pro (MacOS 13.0.1) i9 Processor, 32gb RAM, 4tb SSD
(STUDIO I/O) MOTU UltraLite mk5 (w/ADA8200), (LIVE I/O) Behringer X Air XR18
Ableton Live Suite 11 (Live performances), Studio One 5 (Studio Stem Creation)
(STUDIO I/O) MOTU UltraLite mk5 (w/ADA8200), (LIVE I/O) Behringer X Air XR18
Ableton Live Suite 11 (Live performances), Studio One 5 (Studio Stem Creation)
Re: [MacOS] Virtual Outputs?
MacBook Pro (MacOS 13.0.1) i9 Processor, 32gb RAM, 4tb SSD
(STUDIO I/O) MOTU UltraLite mk5 (w/ADA8200), (LIVE I/O) Behringer X Air XR18
Ableton Live Suite 11 (Live performances), Studio One 5 (Studio Stem Creation)
(STUDIO I/O) MOTU UltraLite mk5 (w/ADA8200), (LIVE I/O) Behringer X Air XR18
Ableton Live Suite 11 (Live performances), Studio One 5 (Studio Stem Creation)