Here is the thing: I use a Korg NanoKontrol2 controller to make rough mixes in Ableton Live 10. But when I have more than 8 tracks (always!) and I push the key to reach the next 8 tracks I only can do that once, because when I come back to the first 8 tracks, all faders are in the wrong position to fine-tune the first tracks etc.
So, I want to combine 2 of these midi controllers. Only, when I connect them, Ableton recognises only one of them.
What do I have to do to combine two of these controllers (next to another) so that Ableton "sees" one midi controller with 16 faders?
Combine 2 Korg NanoKontrol2 devices
Re: Combine 2 Korg NanoKontrol2 devices
I've tried everything that I could find on internet. The best "solution" was to link one device via a Mackie control surface and the other just link and than define its behaviour via the "midi button" inside Ableton. But even then things went gaga: some sliders took over the action of others etc.
Conclusion: I'm going to buy a 16 channel controller like the Presonus faderport 16. A cheaper solutions should be the Behringer X-Touch compact: the faders adapt to the settings inside Live!
Enough time lost, now more creativity!
Conclusion: I'm going to buy a 16 channel controller like the Presonus faderport 16. A cheaper solutions should be the Behringer X-Touch compact: the faders adapt to the settings inside Live!
Enough time lost, now more creativity!
Re: Combine 2 Korg NanoKontrol2 devices
See the section on Takeover Mode in the manual. Set it to Value Scaling and faders and pots will act more like rotary encoders, starting at the current parameter value and changing it in the direction you move the control. It's not WYSIWYG like motorized faders.
Re: Combine 2 Korg NanoKontrol2 devices
To conclude this subject: there was no real good solution, so I've purchased a Presonus Faderport 16. This means 16 motorised faders and a lot of controls.
I want to be creative without stumbling over technical issues.
I want to be creative without stumbling over technical issues.
Re: Combine 2 Korg NanoKontrol2 devices
To conclude this subject: there was no real good solution, so I've purchased a Presonus Faderport 16. This means 16 motorised faders and a lot of controls.
I want to be creative without stumbling over technical issues.
I want to be creative without stumbling over technical issues.