I am trying to edit the script so I can use the Keylab 49 MKII with all the 16 macros.
Only works up till encoder 8![DeviceControls]
# The Encoders will control the device parameters (you can also
# use knobs or sliders). Replace the -1's with the CCs sent by
# the respective controls on your controller. You can also set
# the channel for each controller if it differs from the global
# channel (if you leave the channel of an encoder at -1, Live
# will assume that the encoder uses the global channel).
Encoder1: 73
Encoder2: 75
Encoder3: 79
Encoder4: 72
Encoder5: 80
Encoder6: 81
Encoder7: 82
Encoder8: 83
Encoder9: 77
Encoder10: 76
Encoder11: 71
Encoder12: 74
Encoder13: 93
Encoder14: 18
Encoder15: 19
Encoder16: 16
EncoderChanne1: -1
EncoderChanne2: -1
EncoderChanne3: -1
EncoderChanne4: -1
EncoderChanne5: -1
EncoderChanne6: -1
EncoderChanne7: -1
EncoderChanne8: -1
EncoderChanne9: -1
EncoderChanne10: -1
EncoderChanne11: -1
EncoderChanne12: -1
EncoderChanne13: -1
EncoderChanne14: -1
EncoderChanne15: -1
EncoderChanne16: -1
Yes you can have up to 3 banks on "User Mode", but MKII is sending CC from all faders and knobs with bank 1 if you map manually.
My guess is that Ableton needs to update the script, because obvious just putting new lines for the rest of the encoders, it does not work.
Anyone found a solution?