Behring FCB-1010 Problem W/ Live

simsm · Post by **simsm** » Fri Aug 19, 2005 3:47 pm

Hello fellow ableton-ers, I have run into a problem w/ using my Behringer FCB-1010 w/ Live v5. I downloaded a MIDI sysex file to the Behringer unit that programmed it to send note-on messages (10 per patch) and continuous controller messages (2 per patch). I enabled the 1010's port in Live for MIDI control, and mapped parameters to the 1010's buttons and pedals. Things worked well in the initial patch, but when I scrolled from patch to patch, the 1010 started sending different MIDI messages (even when I found my way back to the initial patch). I'm wondering if anyone else has run into this, or has a link to an alternate sysex file that integrates well w/ Live's MIDI functions. Thanks very much.

Matt
--
matt sims
http://www.mattsims.org

Machinate · Post by **Machinate** » Fri Aug 19, 2005 4:22 pm

I think the problem is that you loaded the sysex file just fine, but didn't save it properly. IIRC you're supposed to hold down some button for 4 seconds or something.

simsm · Post by **simsm** » Fri Aug 19, 2005 6:39 pm

I'll try loading the sysex file again. Thanks for the reply.

Cheers,
Matt