Is Midi out correctly set?
Yes. But I will figure it out. Yesterday it worked.
I think it the reason should be searched in MIDIYoke.
- When I use the recommended cofiguration and route the output from Live to MIDIYoke, to huskerVU and from there back into the BCR I get these failures.
- So I tried to avoid MIDIYoke: I routed the output of Live to an hardware MIDI-Out on the Multiface, looped it back in (short cable between MIDI-Out and -IN) and used this Multiface MIDI In as source in HuskerVU. It worked without a problem. Pageswitching and proper update of the display. The Input of the BCR was not connected. Maybe you can reproduce this?
bd
edit: yes, it is a MIDIYoke problem. I tried a solution with MIDI only and it worked perfect.
1) The BCR has to be in Mode S4.
2) You need an interface with three MIDI-Ports. Two IN and one OUT.
3) Connect the BCR MIDI-Out to one MIDI-IN and the MIDI-OUT to the BCR MIDI-In A and choose these ports in Live as Mackie Control In and Out ports respectively.
4) For the Display: Connect MIDI-Out B of the BCR to the second MIDI-IN of your interface and choose this interface in HuskerVU. The MCU Output will be routed through the BCR and back into your interface.
It works perfectly here, call back the ableton guys, they're software is perfect (as if we didn't know this already).
bd