Page 1 of 1

A way to turn on/off plugins in clip envelopes?

Posted: Fri Feb 24, 2006 3:10 pm
by tomperson
Is there a way to turn on/off plugins with clip envelopes? I couldn't find that. The only way I can imagine now is to assign a midi note to plugin on/off, and then doing a clip that sends that midi note out to midi yoke and then loop it back to the track in question...which seems a bit overkill for something so simple...

Any ideas?

Posted: Fri Feb 24, 2006 7:11 pm
by Michael Hatsis
If a plug has a wet - dry param. you could use envelopes to go from say 40% wet to 0% wet. Or, for instance you are using a compressor( no wet/dry ).You can use an envelope to set the threshold way up high, so the compresser isnt catching anything.

Posted: Mon Feb 27, 2006 3:35 pm
by tomperson
No, no, I don't want to control the dry/wet, I want full device ON/OFF. In arrangement automation it's there, but in session envelopes not. I don't want that plugin eating CPU cycles unless I really need it (and I really need it in just parts of my set).

Posted: Mon Feb 27, 2006 4:25 pm
by stallos
I've been looking for this too.

I like using it in arrangement mode but if you could do it session view too - that would be delightful!


heres hoping!

Posted: Mon Feb 27, 2006 5:39 pm
by pulsoc
I'm not an expert, but from what I can tell the answer to question is "no".

I think this has been mentioned in the "feature request" forum as well.

Posted: Mon Feb 27, 2006 6:02 pm
by atmofunk
afaik even if you turn the device off it's still gonna eat CPU anyways