Bad sound !!!!!!!!!

mja · Post by **mja** » Fri Nov 16, 2007 8:22 pm

Well ive just purchased a pair of tannoy studio monitors and a maudio fast track pro,my question is,in abletons preference section under audio device what should i have my drivers set to ?For the past week r so ive had the input and output set to fast track pro Dx but i keep getting little pops and clicks in the sound ive also tried fast track pro wave,conexant amc audio dx and conexant amc audio wave but im still having the same problem.I used to use my internal soundcard before i purchased the fast track pro and i never had this problem.I would really apreciate a bit of help,cheers mike.

sweetjesus · Post by **sweetjesus** » Fri Nov 16, 2007 8:24 pm

in lives audio pref's choose the ASIO driver.

then in hardware setup, play with increasing your latency to reduce clicks/pops

mja · Post by **mja** » Fri Nov 16, 2007 8:26 pm

I dont think i have that driver,do you have a link so i can download it.

mja · Post by **mja** » Fri Nov 16, 2007 8:30 pm

Just downloading it now thanks for your help.

mja · Post by **mja** » Fri Nov 16, 2007 9:07 pm

Im still getting pops and click and im after setting the latency to 375 ms,should this be happening ?

Meef Chaloin · Post by **Meef Chaloin** » Fri Nov 16, 2007 11:05 pm

on an asio driver? no definitely not, you can normally get it below 60ms with no probs

mja · Post by **mja** » Fri Nov 16, 2007 11:41 pm

Does anybody else know what could be wrong.