Motu Ultralite question

FavoriteStation · Post by **FavoriteStation** » Mon Oct 20, 2008 9:21 pm

Hey everyone, I have a question. I have a Motu Ultralite and am trying to use multiple outputs for my studio monitors. So basically I have 4 yamaha studio monitors that I want to use at once. So the issue I am having is I can only seem to select either the main outputs or analog 1-2 or analog 3-4 analog 5-6 etc. I am trying to use the main outs & analog 1-2 simultaniously. Any suggestions etc? Thanks!

jacob_ma · Post by **jacob_ma** » Tue Oct 21, 2008 6:05 am

why on earth would you want' to do that???

Try mixing on one set of speakers at a Time!!! You will get better results

966sf · Post by **966sf** » Tue Oct 21, 2008 8:25 am

Why don't you just create a return track for each monitor. Have your sends post fader and set to 0dB so you are reflecting the output of the fader. Assign to each return to it's respective outputs in Ext. Out and you should be good to go. Maybe.

kueland · Post by **kueland** » Tue Oct 21, 2008 10:44 am

This can be done in two ways:

1. Assign Cue out to analog 1-2, and master out to Main out. Then just turn on the cue switch for all the tracks your using. This works fine for me (Running cue output to stage monitor, and master out to FOH).
2. Create an audio track that has its input from master, and its output set to analog 1-2. Enable monitoring on that track and you're good to go:-)

Hope this helps.

Motu Ultralite question

Motu Ultralite question

Multiple outs - MOTU Ultralite