All times are UTC

 
 



Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Select value to display instead of 0-127 on macros
PostPosted: Thu Aug 30, 2018 6:31 pm 

Joined: Sat Mar 08, 2008 5:12 pm
Posts: 122
Location: Wuppertal (Germany)
When you map multiple parameters to a macro, that have not exactly the same type of value, it doesn't show the value of the parameter anymore but only a number between 0 and 127. Even when you map it to two different dry-wet-parameters where one has whole numbers and the other one a decimal point.

By default, the macro could still display a number between 0 and 127 but you should be able to choose one of the mapped parameters that should provide the value that is displayed. This could be just a little checkbox in the macro mapping editor. Instead of showing 0 to 127 by default when more than one parameter is mapped, the value of the first parameter that was mapped could be displayed, but you still should be able to change it.

For example, if I map the filter frequency to a macro but I also map the gain of a Utility, so the sound gets a little bit more volume when the filter is turned down, then I still want to see the Hz value, neither the dB value nor the 0-127 value.

Of course, this should also change what happens when I select "reset to default on that macro. In that case, it's set to the default value of the parameter that was selected in the mapping editor. If the default value of that parameter is not in the mapped range then it's set to the closest possible value.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC

 
 

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group