recording automation to clips
recording automation to clips
i want to record controller movements into midi clips just like with the pitchbend and modwheel. i know it works in arrangement view, but not in clip view.
is it impossible or am i just missing something?
cheers
is it impossible or am i just missing something?
cheers
Asus F3Sv 2x2.2 Ghz, 2 GB RAM, WinXP | Edirol FA-66 Firewire | Live 7.0.2
-
- Posts: 589
- Joined: Sat Aug 02, 2003 4:40 pm
Re: recording automation to clips
The only way to do it is to record automation in arrange view and then copy the envelopes to the clip one by one. But be aware that automation is absolute values, while clip envelopes are offset values. So to make sure the sonic result is the same, you would have to set the knobs for the envelope driven parameters to either center position or maximum position (depends on the type of parameter, i.e. if the clip envelope is unipolar or bipolar).scyhte wrote:is it impossible or am i just missing something?
Please! +1+1+1
Session view isn't only for jam sessions, it can be used to make a song too! This is why it should be possible to record automation to clips too and not only in arrangement mode!
Session view isn't only for jam sessions, it can be used to make a song too! This is why it should be possible to record automation to clips too and not only in arrangement mode!
Juhana Lehtiniemi - Film composer with Ableton Live
-
- Posts: 3
- Joined: Tue Jan 23, 2007 3:01 am
it's a little bit tricky but it's working...
in preferences:
#config (all those are not ON are OFF):
INPUT
BCF2000 -> remote ON
and make your assignations.
#using
INPUT
IAC -> remote ON
BCF2000 -> track ON
OUTPUT
IAC -> track ON
BCF2000 -> remote ON
in session window:
create a midi track.
IN = BCF2000 ch1
OUT = IAC Ch1
and now when you record on this track, automation will play in live.
just one problem:
controllers are only implemented from 1 to 119 !!!
WHY ?
and WHY didn't you implement CC0 ?!?
faderfox use CC0 on ch15.
(so i need to use a max patch to route CC from fader to live)
and WHY don't you authorize to go out to all channels ?
greetz.
in preferences:
#config (all those are not ON are OFF):
INPUT
BCF2000 -> remote ON
and make your assignations.
#using
INPUT
IAC -> remote ON
BCF2000 -> track ON
OUTPUT
IAC -> track ON
BCF2000 -> remote ON
in session window:
create a midi track.
IN = BCF2000 ch1
OUT = IAC Ch1
and now when you record on this track, automation will play in live.
just one problem:
controllers are only implemented from 1 to 119 !!!
WHY ?
and WHY didn't you implement CC0 ?!?
faderfox use CC0 on ch15.
(so i need to use a max patch to route CC from fader to live)
and WHY don't you authorize to go out to all channels ?
greetz.
-
- Posts: 188
- Joined: Wed Feb 01, 2006 8:09 pm
- Location: Las Vegas, NV USA
- Contact:
I also assumed this was possible.. I am considering the switch from Cubase to produce.. I was impressed by how usable automation was (when using the mouse). figured recording that with a midi knob was already implemented.. WTF????? Yes all we need is a button for this to enable/disable. I would like to write a rough draft in the session view. working from section to section in a loop then record to arrangement.