master FX on all output busses

amo · Post by **amo** » Sat Jun 19, 2004 10:47 am

subject tells it.... I'd be pleased to see all out busses able to play through FX....

Guest · Post by **Guest** » Sat Jun 19, 2004 10:48 am

noisetonepause · Post by **noisetonepause** » Sat Jun 19, 2004 2:34 pm

howd you do this without either mixing them or running them tthrough seperate instances of the same effect?

-Paws

amo · Post by **amo** » Sun Jun 20, 2004 10:33 am

I just mean to get x master output and not one master output and x bus outputs with just volume

Komplex · Post by **Komplex** » Mon Jun 21, 2004 1:05 am

this would be a great feature for those that mix on external mixers.

gaspode · Post by **gaspode** » Wed Jun 23, 2004 2:07 pm

I don't understand how this function would be different from either putting any fx you need on your master out bus... or if you were using an external mixing console using that to finalize the mix... I guess I don't understand the requested feature

amo · Post by **amo** » Fri Jun 25, 2004 8:00 am

I mean that I use 4 stereo outputs plugged into a mixing board. I'd like, as an exemple, to be able to put a compressor on each output, not only on the two first ones that are the master output.

cheers

robbmasters · Post by **robbmasters** » Fri Jun 25, 2004 8:41 am

Use send channels as group output channels (with the channels being sent ste to "sends only")?

amo · Post by **amo** » Fri Jun 25, 2004 8:43 am

cheers.... but then no sends anymore.... ok with live4 and 8 aux busses though.

robbmasters · Post by **robbmasters** » Fri Jun 25, 2004 8:54 am

amo wrote:but then no sends anymore....

If you use three sends and the master, you've got one send left...

But I can see that that may not be enough. Roll on Live 4.

gaspode · Post by **gaspode** » Fri Jun 25, 2004 12:23 pm

so is the request to be able to place sends on each 'output' channel... ie on an imagine sound card "output 1 2" which is probably your master channel... but likewise sends on "output 3 4" and "output 5 6" for example...

and this is something else I have kinda grumbled about myself... it'd be kind of nice to have an fx that you could apply to your preview of loops, so you could have the output of the loop match what is on your master output fx... but I suppose it isn't 100% necessary.

master FX on all output busses

master FX on all output busses

sorry, should be in the feature wishlist....

huh?

ah...