Record Full Measure [Tail]

Questions and discussion about building and using Max for Live devices
Post Reply
toddincharlotte
Posts: 2
Joined: Fri Jan 18, 2019 10:00 pm

Record Full Measure [Tail]

Post by toddincharlotte » Fri Jan 18, 2019 10:02 pm

I am using Launchpad to do some live looping. I have wet reverbed/delayed guitar signal coming in from my amp. I usually trigger the end of recording a clip on beat 2 of the measure prior to the end of the clip so I can arm the next track for the next loop.

I noticed that my audio gets chopped at beat 2 when I hit the pad even though I get a blinking red light fedback to me. Is there a setting to "enable trails" or something like that?

toddincharlotte
Posts: 2
Joined: Fri Jan 18, 2019 10:00 pm

Re: Record Full Measure [Tail]

Post by toddincharlotte » Sat Jan 19, 2019 3:02 am

Solved my own problem. I was arming a different track directly after I finished the other one and causing the other track to get cut [disarmed]. Just unchecked exclusive arming to arm more than one at a time and it works like a champ.

Post Reply