Clips and pops at the end and start of samples...help!

Brandonmaster · Post by **Brandonmaster** » Thu Apr 07, 2005 4:10 pm

Is there an envelope or way of reducing or fading the end and start part of clips to a zero crossing point to prevent clips and pops on samples that do not end or start at zero crossing.

This is most apparent when clips have been chopped at sliced.

Please help

Many thanks

kabuki · Post by **kabuki** » Thu Apr 07, 2005 5:11 pm

Its in the manual.

kabuki · Post by **kabuki** » Thu Apr 07, 2005 5:12 pm

But after quick concideration, I'll tell you (instead of suggesting you actually read teh manual.

Turn on the "Fade" button on each clip to prevent the pop.

Lower left panes, abobe the transpose knob

kabuki · Post by **kabuki** » Thu Apr 07, 2005 6:36 pm

netx too teh spelchek buton