Motu Ultralite Question

FavoriteStation · Post by **FavoriteStation** » Mon Oct 20, 2008 9:17 pm

Hey everyone, I have a question. I have a Motu Ultralite and am trying to use multiple outputs for my studio monitors. So basically I have 4 yamaha studio monitors that I want to use at once. So the issue I am having is I can only seem to select either the main outputs or analog 1-2 or analog 3-4 analog 5-6 etc. I am trying to use the main outs & analog 1-2 simultaniously. Any suggestions etc? Thanks!

Razzkazz · Post by **Razzkazz** » Tue Oct 21, 2008 1:01 pm

Use busses on a pre-fade send on tracks you want route to outputs other than main out

966sf · Post by **966sf** » Tue Oct 21, 2008 4:29 pm

You should use post-fader sends so it reflects anything you've done to the faders so you would be listening to the same mix on both sets of monitors and not just the levels you recorded to Live.

Razzkazz · Post by **Razzkazz** » Tue Oct 21, 2008 5:23 pm

Forget using the sends actually, why dont you configure an additional external out and route relevant tracks to appropriate out instead of master?

mattstan · Post by **mattstan** » Tue Oct 21, 2008 9:28 pm

Yea the only problem is I want all of the sound from all tracks going to both sets of speakers. So I think I will have to configure the post fader sends and try that. Thanks for the help everyone!

stjohn · Post by **stjohn** » Wed Oct 22, 2008 12:58 am

u could send everything to an individual track X before onto the master channel, and then take an audio in from X to a new track Y..

Clearscreen · Post by **Clearscreen** » Wed Oct 22, 2008 1:43 am

can't you do some sort of bus routing in the motu routing software that'd save live adding more cpu? i haven't used it but i got the impression you could do that when i looked at buying one.

swishniak · Post by **swishniak** » Sat Oct 25, 2008 3:48 pm

ive heard about "mirrored outputs" = i think its 11-12 on the ultralite that send the same signal as the main outputs.