M4L Launchpad Sequencers and User2 Mode not working

[eatriwave]

I've been working on a Step Sequencer for the Lauchpad in Live 8. Sequencer doesn't work properly in Live 9 anymore.
The Problem is that no MIDI messages are sent to Live in USER2 Mode.
The current state of the sequencer is displayed on the Lauchpad but pressing any buttons has not effect.
This is not just the case with my own Step Sequencer but also the Sonic Faction Hatchet Step Sequencer and the Launchpad Sequencer from Novation themselves.

[3osc]

Whew. I thought this was just me.

[S4racen]

Navigate within the patch and find any elements that a looking for a 1 or 0, these need to read a 127 or 0... This is due to the velocity sensitivity introduced with the Push...

Both of the devices you mention are not Ableton devices so you are better off directing your queries to the designers of them...

Cheers
D

[eatriwave]

Navigate within the patch and find any elements that a looking for a 1 or 0, these need to read a 127 or 0... This is due to the velocity sensitivity introduced with the Push...
D

Thanx a lot, Sequencer is up and running again.

[JorJe_GonZa]

I didn't understand what need to change

[ericby]

bonjour.
same problem for me ...
and i don.t find the place to change 0 and 1 to 127 and 0 ...
help !!
merci

[docprosper]

Navigate within the patch and find any elements that a looking for a 1 or 0, these need to read a 127 or 0... This is due to the velocity sensitivity introduced with the Push...

Both of the devices you mention are not Ableton devices so you are better off directing your queries to the designers of them...

Cheers
D

Thanks Darren, marked for future reference...

[ericby]

what.sss!

[sans soleil]

hi - same problem running live 9.0.3 on a mac. it seems to me that the launchpad should sort of qualify as an ableton device, btw...the unit carries their logo on it.