Page 1 of 1

[46664075] Amp not functioning in ReWire mode

Posted: Wed Mar 20, 2013 12:06 am
by tnaf
I have a session with multiple tracks being sent to a Track In, which has Amp running on it. It sounds amazing... if you're running Live as a master.

If you then have another host, and run Ableton as a slave, all of a sudden Amp does not react. It shows that it's on and active, but the audio passing through it is essentially dry.

I've doubled checked all routing to make sure it's not somehow skipping the Track In while getting to the host, and everything visually looks correct. Even placed some really obvious Filter and Reverb patches on the bus, 100% wet, and the audio is then completely effected. So nothing wrong there.

Can anyone else confirm the same issue?

Re: Amp not functioning in ReWire mode

Posted: Thu Mar 21, 2013 8:04 pm
by [nis]
Confirmed. We have this tracked internally.

Thanks!
Nico