Ableton Forum

Global Quantisation dont work ! ...when using the arrows to start scenes
they start imidiately and ignoring the global quantisation of the controlbar.

to switch between scenes while in notemod it is proper to use the navi-arrows of push...
but the global quantisation not working there - this leads to not playling samples
or not triggered notes while the swithes are done, because the scenes are not started
the same way like when i start them in session-mode via scene-launchbutton.

i tried to mess around with the clips launch-properties but i did not help in no triggermode-variation.
after that i tried to solve the proplem by using the audio-clips via sampler triggered by midi - but again
when switching the scene the voicesamples are not played because the start impulseis ignored (overjumped?)

any hint or do i miss(interpret) some signals ?

thx for any help/clearification about that.

yeah. Personally i just hate that you can trigger scenes with up/down arrows in note mode. I think it dangerous in a live situation. Anyway you are right about the 'force legato' behavior, that's a bit odd. But i've read someone lately seeing a feature in it.
viewtopic.php?f=55&t=202700

thx°^^^^

.then for a live situation where i play a vsti via push and same time switch scenes i still need the apc or a launchpad
hooked into the track just to launch the scene...

or

i am simply not fast enough to switch betweenn the note-mode and session..but i need to access both at the same time and so far
i know 2 push dont work.. stupid

they need to apply an option into the "workflow user-setup"
to choose between clip-launch and scene seems not good enough

Tagor wrote:thx°^^^^

.then for a live situation where i play a vsti via push and same time switch scenes i still need the apc or a launchpad
hooked into the track just to launch the scene...

or

i am simply not fast enough to switch betweenn the note-mode and session..but i need to access both at the same time and so far
i know 2 push dont work.. stupid

they need to apply an option into the "workflow user-setup"
to choose between clip-launch and scene seems not good enough

you can push and hold session button while in note mode. when you release it you switch back to note mode - right where you were before.. hope that helps...

thx.. nice it work also in the other way - to shift-note while in session.

Tagor wrote:thx.. nice it work also in the other way - to shift-note while in session.

yup!!