push skips first beat / step

bennniii · Post by **bennniii** » Thu Apr 03, 2014 7:59 pm

hello folks,

i have an urgent question — and i'd be really really gracious if anyone could help out.

when i sequence a clip with my push controller (meaning i have an empty slot and start its recording by programming a sequence on push),
the very first beat of this clip is always skipped (the very first time)... as if the step / note would arrive "in ableton" later than the command to
actually start playing the clip.

any clue?
thank you.

joeyfivecents · Post by **joeyfivecents** » Sat Apr 05, 2014 6:34 am

Yes. I've posted about this and emailed tech support. Doesn't seem like anyone really cares. It makes Push unusable for me.

bennniii · Post by **bennniii** » Sat Apr 05, 2014 10:31 am

good to know :/
i'll do the same and let you know if anything comes up.

hirse · Post by **hirse** » Tue Apr 08, 2014 4:45 am

i had the same problem. in my case i just had to quantize the steps then it worked.

eyecompellya · Post by **eyecompellya** » Sat Apr 26, 2014 3:38 am

happening to me too. quantizing is irrelevant

bennniii · Post by **bennniii** » Sat Apr 26, 2014 12:17 pm

same here.. i've written ableton and sent them a status report —
apparently they'll be looking in to the problem.

keep our fingers crossed. damn :/

push skips first beat / step

push skips first beat / step

Re: push skips first beat / step

Re: push skips first beat / step

Re: push skips first beat / step

Re: push skips first beat / step

Re: push skips first beat / step