Push2 pads brightness threshold powered by USB, solutions?

Come here to discuss Push with other users.
For tech support, please head to http://www.ableton.com/help
Post Reply
Aken
Posts: 18
Joined: Fri Apr 05, 2013 5:08 am

Push2 pads brightness threshold powered by USB, solutions?

Post by Aken » Thu Mar 01, 2018 11:07 pm

Hello!
I'm testing Ableton Live 10 for a few hours now only connected by USB and I'm facing the brightness issue: when hitting a pad with a sensitivity lower than 60, the hit won't show up at all in the step sequencer.

I think this is totally nuts, because it means you cannot play subtle when on the go. I tried to adjust the brightness in the Push setup page but it is already at 100%. So I have 2 questions:

1) Does anyone know how to adjust or remove that stupid brightness threshold so I can play low sens fingerdrumming while not being pluged with the power cord?

2) If it isn't possible, do you think there is a way to map the full sens scal to values located between 60 and 127 so I'm able to see all my hits in the step sequencer?

Thank you in advance for any answer to this ^^

Post Reply