Page 1 of 1

How to clean the rubbery coating on the sides of Push 2?

Posted: Sun Dec 02, 2018 11:10 pm
by petrhosek
The rubbery coating on the sides of my Push 2 has become sticky over time. I tried cleaning with damp cloth but it hasn't helped at all. I considered using isopropyl alcohol but I'm concerned that it might damage the coating. Does anyone have any tips for these surfaces?

Re: How to clean the rubbery coating on the sides of Push 2?

Posted: Thu Dec 27, 2018 7:48 am
by starving student
did you find a good solution for this?

Re: How to clean the rubbery coating on the sides of Push 2?

Posted: Thu Dec 27, 2018 1:15 pm
by Lovelights
Here is one clever trick, wait til he gets to the rubber pads

https://youtu.be/zHgV2g691o8

Best regards


http://www.lovelight.biz/

Re: How to clean the rubbery coating on the sides of Push 2?

Posted: Thu Dec 27, 2018 5:50 pm
by H20nly
Swiffer!

:lol:

Genius!!

Re: How to clean the rubbery coating on the sides of Push 2?

Posted: Fri May 10, 2019 9:14 am
by starving student

Re: How to clean the rubbery coating on the sides of Push 2?

Posted: Sun May 19, 2019 9:18 am
by fishmonkey
i recently noticed that my Push 2 is having the same issue where the TPE coating is degrading and getting sticky.

Ableton support said that they think it is to do with heat or sunlight, but my unit has definitely never been in the sun, nor close to a heater...