Page 1 of 1

Push 2 MIDI mapping with EZDrummer 2

Posted: Wed Nov 27, 2019 5:49 pm
by rabs

I am using EZDrummer 2 with Push 2. I would like to change the midi mapping to be able to layout the EZDrummer sounds in a better way on the Push for finger drumming reasons.

Unfortunately, EZdrummer does not allow you to change the midi mapping of the notes within the plugin. So is there anyway to change the MIDI notes that are assigned to the pads on the PUSH. I can't seem to work it out, and not even in USER mode....any ideas greatly appreciated!

Re: Push 2 MIDI mapping with EZDrummer 2

Posted: Tue Dec 03, 2019 7:02 pm
by jeblo05
Group EZ drummer into a drum rack (cell/pad 1).
Add an external Instrument to the 2nd pad.
Configure „MIDI to“ of the external Instrument point to the same track > EZ Drummer.
Enable IO view in the drum rack. Set „play note“ to the note you want to send from pad 2 to EZ drummer.
Duplicate this chain. Change receive note (one note higher), change play note.
Repeat until you have assigned all pads...

Check Jester‘s tutorial for more details: