Hey everyone,
Just a long shot question here - does anyone know if it's possible to launch a scene or a clip in tandem with the note repeat function? So instead of the way it triggers midi note data inside a clip, it would be starting/launching either a clip itself (audio or midi) and/or even better, "repeat" the launch of a scene with the same note length/repeat rate as if it were a midi note.
I am probably expecting this to be a no but would be amazing if this was possible. Basically trying to work out how I would "repeat" trigger a section in a track (collected as a scene) where I have a bunch of clips on different tracks where each track is going to a different audio output of my interface. Otherwise I'm sure the obvious thing to do would just be to bounce the section of the song to a stereo waveform and stick it in a sampler then just treat the whole thing like the typical midi note repeat function you would expect.
Any help much appreciated!
Thanks,
G
push 2 note repeat to launch scenes/clips?
-
- Posts: 2
- Joined: Thu Sep 08, 2022 1:35 pm
Re: push 2 note repeat to launch scenes/clips?
Nope.
But it would be doable with M4L.
But it would be doable with M4L.
Ableton Forum Moderator
-
- Posts: 2
- Joined: Thu Sep 08, 2022 1:35 pm
Re: push 2 note repeat to launch scenes/clips?
Ahhh yes, didn't think of that, will go down this route for sure... Thanks!