push 2 note repeat to launch scenes/clips?

Discuss Push with other users.
Post Reply
grebby_garbo
Posts: 2
Joined: Thu Sep 08, 2022 1:35 pm

push 2 note repeat to launch scenes/clips?

Post by grebby_garbo » Thu Sep 08, 2022 1:42 pm

Hey everyone,

Just a long shot question here - does anyone know if it's possible to launch a scene or a clip in tandem with the note repeat function? So instead of the way it triggers midi note data inside a clip, it would be starting/launching either a clip itself (audio or midi) and/or even better, "repeat" the launch of a scene with the same note length/repeat rate as if it were a midi note.

I am probably expecting this to be a no but would be amazing if this was possible. Basically trying to work out how I would "repeat" trigger a section in a track (collected as a scene) where I have a bunch of clips on different tracks where each track is going to a different audio output of my interface. Otherwise I'm sure the obvious thing to do would just be to bounce the section of the song to a stereo waveform and stick it in a sampler then just treat the whole thing like the typical midi note repeat function you would expect.

Any help much appreciated!
Thanks,
G

[jur]
Site Admin
Posts: 5307
Joined: Mon Jun 01, 2015 3:04 pm
Location: Ableton

Re: push 2 note repeat to launch scenes/clips?

Post by [jur] » Thu Sep 08, 2022 8:35 pm

Nope.
But it would be doable with M4L.
Ableton Forum Moderator

grebby_garbo
Posts: 2
Joined: Thu Sep 08, 2022 1:35 pm

Re: push 2 note repeat to launch scenes/clips?

Post by grebby_garbo » Wed Sep 21, 2022 4:06 pm

Ahhh yes, didn't think of that, will go down this route for sure... Thanks!

Post Reply