Ableton Push: Questions & Answers

[matkatmusic]

I am not sure if this was answered already in that first post in this thread.

I have an access Virus TI2 that is my primary controller. is it possible to use PUSH to control the start/stop of recording parts, but trigger the notes/use the knobs from the Virus? I guess that would be using two controllers simultaneously. I primarily use the VIrus as an External MIDI instrument, because the latency with the TI plugin renders it somewhat unusable. For that matter, can PUSH be used as a remote transport DAW control/editor alongside a separate controller? Basically use another controller in place of the PUSH pads but still using PUSH for everything else it's intended for.

[vitaphone]

I am not sure if this was answered already in that first post in this thread.

I have an access Virus TI2 that is my primary controller. is it possible to use PUSH to control the start/stop of recording parts, but trigger the notes/use the knobs from the Virus? I guess that would be using two controllers simultaneously. I primarily use the VIrus as an External MIDI instrument, because the latency with the TI plugin renders it somewhat unusable. For that matter, can PUSH be used as a remote transport DAW control/editor alongside a separate controller? Basically use another controller in place of the PUSH pads but still using PUSH for everything else it's intended for.

Yes, Yes, Maybe.

[501dubz]

can i use push for ableton live control while live is running as rewire?

[#1thelark]

How can I add a midieffect to the selected track with push?
Add Effect only brings up audioeffects..

[ezelkow1]

+1

I had been wondering this since it says you can in the video but they never actually show it, and you never see midi effects listed on the push screen

[#1thelark]

got it. shift+Add Effect. For effects left of the active device.
RTFM .

[Silicium]

ahoi,

just got my push and have two questions about.

first of all, on the front and on the back of push is some kind of
an fixation notches. is there any additional hardware to attach planned for push?


and additional regarding Firmware Updates:
where can i find firmware changelogs?


Marco

[corporation]

first of all, on the front and on the back of push is some kind of
an fixation notches. is there any additional hardware to attach planned for push?

The future cover/stand

[Silicium]

exactly what i expected

[su-Y]

By the way, when will it be available, any ideas?
Also, anyone tried the bag they are selling?

[Silicium]

as far as i see, its not possible to assign specific drum hits to a pad in live, isnt?

[yur2die4]

I think, select a pad and tap Browse. For me when I do that, it allows me to hot swap drum sounds with blank and occupied slots. If that is what you are asking.

[lo.key]

so, from the Push FAQ: Pads, referring to the touchstrip "You can midi map it to anything in Live using the standard remote midi map. ", how does this work now that the push live script input is not visible to set is as a midi remote?

[yur2die4]

I was wrong.

To load a drum sound into a drum slot, you select the slot and then go to device mode and make sure you are on the layer of that pad, and not the entire kit.

Then when you are in that layer, tap Browse, which, at any moment for any 'Device' selected, will attempt to hot swap into the browser where that device is located. Then you can replace it with something else.

So in short, have the device layer for the pad selected and hit Browse.

[yop44]

Browsing clip is not possible for the moment but I wish it could be possible :

In session mode -> press Select + the clip or clip slot > Shift + Browse ti browse clips!

If you read this Ableton