Make the Slider the Cross Fader?

JLaws · Post by **JLaws** » Tue Jul 23, 2013 3:59 am

I saw ont he board a while back people trying to figure this out. Any progress? Also Id like to be able to mix between 2 tracks using the knobs except I can only use the one set of knobs on top for 1 track. Ususally When I DJ I do phase mixing (cuting out the low end as you bring in the new tracks low end_ but I can only handle 1 track on the knobs at a time. Perhaps a new DJ template is in the works?

JLaws · Post by **JLaws** » Sat Jul 27, 2013 6:43 am

re:dream · Post by **re:dream** » Sat Jul 27, 2013 7:05 am

https://www.ableton.com/en/articles/push-user-mode/ ??

Not sure about the slider though, because it appears to have 'snap back' behaviour...

Because789 · Post by **Because789** » Sat Jul 27, 2013 7:16 am

OT: Thanks for pointing to this article The Finn! I missed that one until today:

"For the output User Port, the Remote switch needs to be enabled to allow visual feedback via Push's LEDs."

JLaws · Post by **JLaws** » Wed Jul 31, 2013 1:39 am

The Finn wrote:https://www.ableton.com/en/articles/push-user-mode/ ??

Not sure about the slider though, because it appears to have 'snap back' behaviour...

Perhaps there can be a script written to turn this off. There has to be a way to make this more functional to DJ with solo.

JLaws · Post by **JLaws** » Fri Aug 02, 2013 12:31 am

JLaws wrote:
The Finn wrote:https://www.ableton.com/en/articles/push-user-mode/ ??

Not sure about the slider though, because it appears to have 'snap back' behaviour...
Perhaps there can be a script written to turn this off. There has to be a way to make this more functional to DJ with solo.

Anyone else figured out how to turn that part it off?

TexasDJ2012 · Post by **TexasDJ2012** » Sun Oct 06, 2013 11:18 pm

Might this article be of assistance?
http://www.soundonsound.com/sos/sep07/a ... h_0907.htm

mylkoa · Post by **mylkoa** » Mon Mar 23, 2015 9:22 pm

I accidentally had the track and remote switches enabled on the Push Inputs and Outputs (Live Port) and was trying to work with a set in session view... got some strange behavior. The Selection Control buttons would turn green, underneath audio effects listed in my tracks, (I was in device mode), and if I pushed the selection control buttons, they would move the faders in a punch-in, punch-out fashion, going from -inf volume to maximum value.

So many places for something to go wrong. Keeps me busy for hours troubleshooting sometimes.

Make the Slider the Cross Fader?

Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?

Re: Make the Slider the Cross Fader?