Sync issues

[saski]

Arrrrgh!! Pulling my (non-existent) hair out!

Trying to get Live to sync USB with a myriad of hardware...finally get it sounding ok...then stop transport and when I start up again the timing has gone to sh!t! Got a couple of electron boxes supposedly sync'd via Overbridge...but they're way out..couple of Moogs - out, ext sequencer - out...

There doesn't seem to be anything consistent happening...super-flakey.

Any suggestions?



Macbook M1rpo//12.6

[chris harbin]

I don't use external synths and the like so I can't comment on that. But I had some "sync" issues with some of my controllers.

What had happened was that there are a variety of "preferences" that needed to be changed. Maybe unrelated to your situation but one was that when I started clips for recording, at first, I always had to "shift/play" (which is also stop) on the Push 2 to start at the beginning of a clip. Turns out, there was a preference for that and once unchecked, it now behaves as expected.

So the point is, try and dig deeper with that, there might be something in that department.

[[jur]]

Hey saski,
did you search on the forum? There's multiple threads about this.
You could also check this or this KB article.

[saski]

Hey saski,
did you search on the forum? There's multiple threads about this.
You could also check this or this KB article.

Thanks. Yes I've read/watched/searched everything there is about this...

So I've just shelled out £20 for a third-party Max device (Clock) that should be standard with LIVE! Works like a treat - but annoyed the R&D guys can't get it right without a bolt on app...

[[jur]]

So I've just shelled out £20 for a third-party Max device (Clock) that should be standard with LIVE! Works like a treat - but annoyed the R&D guys can't get it right without a bolt on app...

You could drop a line to Support, just as a reminder that this affects yet one another user