CV Instrument Pitch issues w RME interface and Roland SH-2

[heretical_audio]

When I use the CV Instrument in Ableton 12 I am able to successfully send a Gate signal to my Roland SH-2, but it does not respond correctly to CV pitch data. I am using an RME UFX III with DC coupled output and 1/4" cables to connect the two pieces of hardware.

What happens is, if I increase the output signal of the CV out on my audio interface to the CV in on my SH-2, the pitch will go higher and if I lower the audio signal the pitch goes lower - however, it doesn't track when I try to play it on my keyboard controller, it just plays the same not across the entire range. Hopefully this makes sense.

any help or insight would be greatly appreciated!

[stringtapper]

Assuming you're running out to Eurorack, you either need to get one of Expert Sleepers "floating ring" 1/4" TRS to 1/8" TS cables, or something like a Male 1/4" TRS to Dual Female 1/4" TS adapter and only come out of one of the female sides.

[heretical_audio]

Assuming you're running out to Eurorack, you either need to get one of Expert Sleepers "floating ring" 1/4" TRS to 1/8" TS cables, or something like a Male 1/4" TRS to Dual Female 1/4" TS adapter and only come out of one of the female sides.

thanks for the input, but I"m not going into Eurorack, but a Roland SH-2 from 1981. It's a simple synth with only 1/4" for both CV and gate:

[stringtapper]

Then you need a 1/4" TRS to 1/4" TS cable to make that work.

[heretical_audio]

thanks so much for the suggestion. I'll give it a go and report back if it worked.