Frequency mono plug-in

[Dan]

A plug-in (or build into Live’s EQ3 plug-in) which can mono a stereo signal in a frequency range.

Example, you have a stereo signal, ranging from 40 Hz to 3000 Hz, but you want the signal to be mono from 40Hz to 1000 Hz and the stereo from 1000 Hz to 3000 Hz.

Anyone, if such plug-in already exist, I would be happy to hear about it!

[Nod]

Check out the excellent GVST plug 'Gmulti' - not only is it an excellent multiband compressor but you have control over the stereo width of the audio in each band. In this case simply negate the compressor settings so it isn't squashing the audio - then set the crossovers to encompass the frequency range you wish to 'narrow' and use the mid-band width control to achieve the effect your after.

http://www.gvst.co.uk/index.htm

HTH

[Dan]

Thanks, I will try this out!

Thou, I still believe is will be a feature for the EQ3 plug-in. Because the best result when working with brainwaves is to mono all polluting frequency at 0-1000 Hz, and only the pure brainwaves should affect the frequencies 0-1000Hz in stereo.

[tylast]

You could always make an effects group with this setup.

[Dan]

Thanks, very interesting post. More reasons why Ableton could build it into a plug-in...

I'm leaving 4 DK, will try when I return...

[Nod]

Thanks, very interesting post. More reasons why Ableton could build it into a plug-in... I'm leaving 4 DK, will try when I return...

Well when you get back mate also try this:

http://www.otiumfx.com/basslane.php

Only does freqs below a certain cutoff but handy for tightening up mixes with stereo 'flab' all the same...