Motu828

Carstn · Post by **Carstn** » Sat May 11, 2002 9:59 am

Is anyone who use Live with MOTU828.
Live dont save the ASIO Ins/Outs in my project.
If I reopen the project all Ins/Outs are still
the master output.
How can I fix this. Thanx

Post by **Alex** » Sat May 11, 2002 5:48 pm

Hello Carstn,

This seems to be a bug but it appears just under specific circumstances so it would be nice if you do the following things so that we can find the problem:

1) Start Live
2) In the audio preferences, select the 828, set the master to "Bus 1/2" and Pre Listen to "Routed through master".
3) Route Track1 to Master, Track2 to "Bus 3/4" and Track3 to "Bus 5/6.
4 ) Save that song.
5 ) Reopen that song (At this point the error message concerning the routing appears)
6 ) Close Live.

After that please send me
- The log file "Live_log.txt" (in ableton preferences folder)
- The file "Live.cfg" (also in ableton preferences folder)
- The song

If you're working on a Mac please send me the files as sit.

regards,
Alex

Carstn · Post by **Carstn** » Sun Jun 02, 2002 6:14 pm

Carstn wrote: Is anyone who use Live with MOTU828.
Live dont save the ASIO Ins/Outs in my project.
If I reopen the project all Ins/Outs are still
the master output.
How can I fix this. Thanx

Post by **Alex** » Mon Jun 03, 2002 2:56 pm

Hello Carstn,

it would have helped me e lot doing the stuff I posted before.

The ins/Outs are saved in a song but if you start Live by doubleclick on a song, all routings are set to again to master.
So the workaround for that is to start Live first and then to load your song.

regards,
Alex

chris_borgia · Post by **chris_borgia** » Fri Jun 07, 2002 7:22 pm

I have the same issue with my 828, i have not tryed it out latly and have uninstalled the drivers, so i cant do the test and then send the log file, but the issue does exsist.

::chris_borgia: