I'm sure this has been gone over before...
I'm looking to build my own midi controller, and will need a midi interface for my MacBook. Ideally, something small, as I'd like to try to fit the interface inside the controller's casing so you'd never see it. Also ideally cheap, as the rest of the controller is probably going to cost a fair bit...
Maybe someone savvier can help me out with another issue relating to this. I'm planning on using the Doepfer Pocket Electronic kit (http://www.doepfer.de/pe.htm), which only allows for 16 knobs/switches/etc. I'd like more than 16, and I know I should be able to use 2 of the Pocket Electronics to do that. Will this mean that I'll need an interface with two inputs?
Depending on the answer to that, I'll need either a 1-in or 2-in interface.
Any help?
Midi interface recommendations?
-
- Posts: 3604
- Joined: Fri Jun 04, 2004 2:57 pm
- Location: The south east suburbs of Malmö, Sweden.
-
- Posts: 3604
- Joined: Fri Jun 04, 2004 2:57 pm
- Location: The south east suburbs of Malmö, Sweden.