midi controllers override

Guest · Post by **Guest** » Sun Jun 13, 2004 8:32 am

I recently bought an x-session to use with my uc-33e, needing more knobs and a proper x-fader, but I have a little problem with some functions that are overriding each other.
Let me explain... I'm using a knob on the uc for panning of track 1, works fine... but when I go in midi mode to map the fader of the x-session, it overrides the pan function.
Anyone got any suggestions?
I can't seem to work this one out.
Help would be much appreciated.
Thanks,
the ar

the ar · Post by **the ar** » Sun Jun 13, 2004 8:43 am

Oops, it didn't log me in.

Lucid · Post by **Lucid** » Sun Jun 13, 2004 8:57 am

ar - you have to figure out how to reprogram one of your two MIDI controllers and give its functions different CC numbers that do not conflict with any of the CC numbers that are being used by the other device.

the ar · Post by **the ar** » Sun Jun 13, 2004 12:48 pm

Anyone got suggestions?

Lucid · Post by **Lucid** » Sun Jun 13, 2004 4:06 pm

Use MIDI CC numbers 1-40 on the Evolution UC-33 and number 41-70 on the X-Session

the ar · Post by **the ar** » Sun Jun 13, 2004 6:32 pm

Thanks Lucid.

the ar · Post by **the ar** » Mon Jun 14, 2004 8:05 am

I can't seem to do anything...

Any good samaritan out there who can help me?
Cheers,
the ar

Lucid · Post by **Lucid** » Mon Jun 14, 2004 3:14 pm

UC-33 Manual page #20

Select a controller ( Fader, Knob, etc )

Press Program

Enter the CC # you would like to assign to the controller ( i.e., CC#s that are not being used by the X-Session )

When you're done, press Memory and select a preset

Good luck

Lucid · Post by **Lucid** » Mon Jun 14, 2004 3:14 pm

UC-33 Manual page #20

Select a controller ( Fader, Knob, etc )

Press Program

Enter the CC # you would like to assign to the controller ( i.e., CC#s that are not being used by the X-Session )

When you're done, press Memory and select a preset

Good luck

Guest · Post by **Guest** » Tue Jun 15, 2004 12:32 pm

if its a uc33e, the enigma software makes programming a snap. The easiest way to seperate midi devices is to use different midi out channels. Just set the xsession to channel two and uc33 to channel one, and make assignments in Live--guaranteed no overlap, should just take a minute.

Ryan