How do I get huskervu to work?
I'm using the BCR2000 Mackie Emulation (from http://www.geocities.jp/mackicrokontrol ... live5.html) and its working fine so far, but I want to use huskervu as well. How should I set it up to work properly? The instructions on the website just tell me to:
"Select a Midi Input. This should be one of your virtual midi ports (like Midi Yoke NT:1).
Select a Midi Ouput. This should be the port your fake MCU is connected to (this is used to pass through the visual feedback info to the controller, like the led rings on a BCR2000)."
Midi input is fine, but I'm not sure which midi output port to use. If i select my BCR output, huskervu crashes with "an unhandled exception"
I assume this is because Live is using the BCR output already (although it's only set to "remote", and "track" and "sync" are switched off as per the instructions on that website).
How do I make it work?!
Huskervu
-
- Posts: 51
- Joined: Wed May 17, 2006 4:42 pm