Live/Reason Rewire problems

spastic · Post by **spastic** » Fri Feb 11, 2005 12:00 am

Sorry if this is idiotic, but I am new.

I want to make Reason the slave in live, but it isn't on the pull-down menu. When I first installed them, I opened reason first, which has probably screwed up my rewire setting. Is there any way to reset them?

Thanks

jasonjbundy · Post by **jasonjbundy** » Fri Feb 11, 2005 3:24 am

In order to make Reason the slave using REWIRE in Live 4:

1. Open Live 4 - wait until it initializes and scans, etc...

2. Then once Live 4 is completely and fully loaded, open Reason and you are done.

3. Look for Reason among the audio and the midi to channels.

Good luck!

spastic · Post by **spastic** » Fri Feb 11, 2005 9:51 pm

Yeah, it doesn't do that. Reason never appears in the channels.

clipperer · Post by **clipperer** » Mon Feb 14, 2005 3:50 am

reinstall reason?

ewistrand · Post by **ewistrand** » Mon Feb 14, 2005 5:59 am

Easiest thing to do is to do a search for ReWire.dlls on your machine.
Delete ALL of them that appear. Now, run your Reason installer again.
It'll put the correct ReWire.dll in the correct location- all the installer will do in this case is replace missing files. Then start up Live. After it's through initializing and completely open, start up Reason.
ew