Ableton Forum

There is no bug or software issue here, you just need to make sure your looping commands are set correctly (the numbers to either side of the yellow loop/cycle button on the top right part of the screen). When you change to 6/4 from 4/4 for example, it still thinks you want to loop at 1 bar of 4/4, until you update this area. If you don't, you'll get the results you are getting.

-M

debz wrote:I wrote to Ableton tech support so if I get an answer I will post here to for you ok.

Great! Fingers crossed.

mholloway wrote:There is no bug or software issue here, you just need to make sure your looping commands are set correctly (the numbers to either side of the yellow loop/cycle button on the top right part of the screen). When you change to 6/4 from 4/4 for example, it still thinks you want to loop at 1 bar of 4/4, until you update this area. If you don't, you'll get the results you are getting.

-M

I noticed the yellow loop button was on so I turned it off and this seems to have resolved it.
I just checked the 3/4 tune and turned off the yellow loop button for that one and it works too.
Thank you mholloway