Ableton Forum

Posted: **Wed May 24, 2006 6:54 am**

too cool, this actually makes me think about the possability of making my own, not to hard you say., good work chaps

Posted: **Thu May 25, 2006 9:39 am**

can you use any old pots and faders or do you need specific types to comply with the midi units.

Posted: **Thu May 25, 2006 3:35 pm**

Nice work. I'm building stuff all the time, I think you just convinced me to build my own controller!

Posted: **Thu May 25, 2006 4:47 pm**

Actually, I cheated a little, the kills are part of the EQ high, mid and low chain, so effectivly, by killing the kills you're turning the same channel as the pots down to 0 and by turning them on, it will resume at what ever value you had the pots set at last.

Great idea!
So the switches are connected in series with the pots? How exactly?

Posted: **Tue Jul 18, 2006 7:27 pm**

nuperspective wrote:can you use any old pots and faders or do you need specific types to comply with the midi units.

I actually put it all into an instructable, and I have the complete parts listing in there in addition to some better instructions.

http://www.instructables.com/id/EHKPT0O22DEPH67CM0

Ableton Forum

forget the 'ultimate DJ controller' and make your own