monome opinions

b0unce · Post by **b0unce** » Fri Jan 25, 2008 9:45 pm

beats me wrote:Hey! Thought I'd bring my whiny bitchiness over to this thread of similar topic. I have no doubt somebody bought a shitload to sell later. With the cool vibe of the monome people and community it would be cool if they limited the amount people could purchase at once, or maybe they do. I couldn't clock in in under 2 minutes to find out. Did they have any doubt these would sell out?

I'm going to go off and buy a Wii now. Oh, wait.

Hey
there was no option to buy more than one monome.

John Sweet · Post by **John Sweet** » Fri Jan 25, 2008 9:58 pm

Strauzzie wrote:when i was originally researching the Lemur, i heard rumors of touch latency. i.e. if you wanted to do some rapid retriggering on buttons you would be SOL

Absolutely. A minimum of 16 ms. If you build big interfaces or add a lot of parsing and the pie chart that tracks memory usage in JazzEditor starts approaching 75% the lag gets worse.

I say 75% because it's the true maximum memory amount. Never mind that the scale goes up to 100, if you try to build 'em that big the JazzEditor might crash, you have to sorta hack the Lemur thru trial & error to install it, and the latency gets so bad you better be using 1-bar quantize for everything.

Mr Man · Post by **Mr Man** » Thu Feb 28, 2008 9:11 pm

doc holiday wrote:The logic is flawed you're right..

but every time i think about it, my mind goes right back to:

if i build one, i should build two

No harm in that, if you have the time/money.

Keep the best!

I was pricing a top plate at the local metal fabricator - no fkn way at the quote they gave.

going to shop around but im thinking if i could source round keypads i could make it all

Tone Deft · Post by **Tone Deft** » Thu Feb 28, 2008 10:11 pm

Mr Man wrote:
doc holiday wrote:The logic is flawed you're right..

but every time i think about it, my mind goes right back to:

if i build one, i should build two

No harm in that, if you have the time/money.

Keep the best!

I was pricing a top plate at the local metal fabricator - no fkn way at the quote they gave.

going to shop around but im thinking if i could source round keypads i could make it all

what an asshole.

Mr Man · Post by **Mr Man** » Fri Feb 29, 2008 12:08 pm

why would that be?

logic_user99 · Post by **logic_user99** » Fri Mar 07, 2008 11:18 am

I just put my name down on the list for a "64" when they're available later in the year... it was that or an "Ohm" controller.

Hmm...