Ableton Forum

Hey gang,
I know I'm totally a pain here. I just got a Digitech GNX3000 and have installed the ASIO drivers and the X-Edit software. I open ABL7 and it sees it but I can't get a signal from it. I am also using Digidesign Audiomedia III soundcard for ASIO output which has been working great for all of the internal instruments. I can use a USB ASIO in and a different ASIO out can't I? Would a driver conflict be the problem?

EDIT! Ok...I'm getting close but not all the way. I'm recording audio but I can't hear it while I'm recording. I'll go back to prefs after I record and change to the "Digi" input and I hear what I recorded playback fine. I want to be able to hear what I play come out of the AMIII card while I play through the GenX via USB.

thanks

With ASIO drivers, you need to use the same device for input and output.

ew

unbelievable...un-friggin'-believable(throws hands up in air). Thanks for the reply.

You can sometimes work around it using ASIO4ALL I believe. Otherwise ewi is correct.