Page 1 of 1
[4650] 8.0b5 gui zoom bug
Posted: Wed Feb 04, 2009 5:56 am
by Tarekith
When you set the GUi to zoom to anything other than 100, save the project, then reopen it, the display is not recalled correctly. Usually the Live GUI disappear off the bottom the page upon reopen.
Posted: Wed Feb 04, 2009 4:35 pm
by Friedemann
Hi,
I'm not sure if I understand the report correctly, could you please describe the exact steps you are doing, including whether you restart Live in between?
Best, Friedemann
Posted: Wed Feb 04, 2009 4:41 pm
by Tarekith
Sure. Open Live, hit F11 to go full screen. Open the preferences, zoom the GUI to 120%, then close Live. Reopen Live, and the zoomed display is not scaled to the screen size, it goes off the bottom of the screen. See screenshot below:
Posted: Thu Feb 05, 2009 1:54 am
by Keddy
I noticed a similar issue with the zoom. If you zoom in and out a few times, eventually the right side of the screen stops coming back into view.
Posted: Thu Feb 05, 2009 6:06 am
by scientist
Keddy wrote:I noticed a similar issue with the zoom. If you zoom in and out a few times, eventually the right side of the screen stops coming back into view.
i can reproduce this. wiggle the zoom amount up and down for a bit, and the lower right corner loses its location and drifts around, sometimes off screen.
unable reproduce tarekith's issue.
