Ableton Forum

Playing around with Looper in 8b11 last night I found I occasionally get clicks at the start of loops. Can you implement a short fade-in and fade-out on the samples to eliminate these? A few msecs fade-in / out of samples should ensure click free looping, which is pretty essential.

I actually wasn't getting any clicks in the 11 beta, but I was having problems with overdub lopping. Like I was getting an instant of silence instead of a click. If they implement a universal fade it would mess up and continuous sounds that go from the end of the bar through the beginning again. I need to be able to do that! Maybe they could have options.

Hi,

Can you try this again with beta 17. The clicks should be greatly improved. There is some fading going on that should at least make them less obvious.

Regards,
Amaury