Ableton Forum

if i insert a marker in the arrangement (or use existing ones), and click on it, nothing happens.
playback doesn't jump to it, as it was the case with 7.0
b12

if i click somewhere in the arrangement, i get an orange 'horizontal' arrow on the top thick line under the marker area.
if i then click on a marker, it turns into a green 'vertical' arrow, but remains at the same place.

i think i had an issue with markers too

i was working on punch ins and had my markers set and midi mapped from liveb11
during a break i downloaded liveb12 and then got back to work.

i hit my marker to cue up the punch in point and hit play.. the song started from the beginning. i tried it a few times but it was late and i needed to get my punch ins done so i set my cue marker as start song from here and finished up.

i'll take a closer look before i start tracking today.

Hi peeddrroo,

can you send a small set that demonstrates the problem, for me everything seems fine.

Best, Friedemann

Hi peeddrroo,

Same here on OSX.
If I stop playing a set and then jump to a marker (with mouse or learned key command) the arrangement is not playing from the marker, its playing from the last insert point and the (orange) insert point is turning into a little green play marker.

If I klick a marker while the set is playing, everything is OK and the playhead is jumping to the marker.

Hi,

if the song is stopped you need to double-click the locator in order to start it there
(cf. section 6.3 in the manual).

Best, Friedemann

Hi,

There were some marker-related bugs fixed a while ago, on top of Friedemann's comment above. Is there any issue left here?

Regards,
Amaury

Amaury wrote:Hi,

Is there any issue left here?

Regards,
Amaury

No