Page 1 of 1
[5104] Audio clip overview shows blank areas in some cases.
Posted: Tue Mar 03, 2009 8:39 am
by dancing Ray
I have a clip of two bars with a warpmarker at the beginning, one in the middle, one at a quarter before the end and one at the end. When I try to shift-drag the marker at the end the audio between the last two markers disappears. All that´s left is a thin line at the top of the clip (between the last two markers).
That part of the clip will be audible no more.
It does not matter in which direction I try to drag the marker.
Re: [amo] Audio disappers when moving warpmarker
Posted: Tue Mar 10, 2009 6:10 pm
by Amaury
Hi,
Can you still reproduce that with b16?
Regards,
Amaury
Re: [amo] Audio disappers when moving warpmarker
Posted: Wed Mar 11, 2009 7:31 am
by dancing Ray
Hi,
no, I connot reproduce it with b16, but still strange things going on (visually only).
- Take short clip
- Warp (pro)
- drag first marker beyond the beginning of the clip (-1 e.g.) and back again
- resize the clip overview at the bottom, so that you can see the whole clip
-> the range that was in the negative will be displayed white in the clip overview (visually only)
- move warp marker again -> everythings fine
Thanks,
Ray
Re: [5104] Audio clip overview shows blank areas in some cases.
Posted: Wed Mar 11, 2009 8:36 am
by Amaury
Hi,
Thanks, I filed that as a bug. In the future, please open new threads for new problems, because it makes it hard otherwise for us, when reviewing a forum thread attached to a bug report.
Regards,
Amaury